DSNMLM Started Task

Michael Dempsey

DSNMLM Started Task
Hey Folks...
We're new to WLM.. When we start the DSNWLM, it ends within 5 minutes
with a CC=0. Is this normal? Or should it always be up and running?

Michael Dempsey
UNC Health Care System



David Booher

Re: DSNMLM Started Task
(in response to Michael Dempsey)
We too are new to WLM and running in the WLM environment. My address spaces
exhibited the same behavior when manually started.

What you should do is switch to GOAL mode "V WLM,MODE=GOAL". Make sure you
have the WLM Environment variables and procedure defined in the Application
section of WILMA and the address space will start automatically when it is
first referenced by the procedure. I have noticed that the address space
stays up longer once it has been referenced, but eventually it will
gracefully shut down.

Dave Booher
Systems Programmer
Quest Software


-----Original Message-----
From: Dempsey, Michael [mailto:[login to unmask email]
Sent: Thursday, January 04, 2001 1:53 PM
To: [login to unmask email]
Subject: DSNMLM Started Task


Hey Folks...
We're new to WLM.. When we start the DSNWLM, it ends within 5 minutes
with a CC=0. Is this normal? Or should it always be up and running?

Michael Dempsey
UNC Health Care System





Kirk Hampton

Re: DSNMLM Started Task
(in response to David Booher)
Michael, I think most likely you are already in Goal mode of WLM, issue
D WLM,SYSTEMS
to verify this. Under Goal mode, if you manually start the Stored Procedure
address space, it will go away after a few minutes of inactivity. If you did
not
see any RRS connect errors or other error messages in the log, it is probably
functioning normally. WLM will start it himself when there is a request for
a stored procedure. Check also to see if RRS is running.
Under Compatibility mode, you have to manually start the address
space, but then it should never go down until you stop it manually, even if DB2
goes down.






David Booher <[login to unmask email]> on 01/04/2001 03:01:21 PM

Please respond to DB2 Data Base Discussion List <[login to unmask email]>

To: [login to unmask email]
cc: (bcc: Kirk Hampton/Texas Utilities)
Subject: Re: DSNMLM Started Task



We too are new to WLM and running in the WLM environment. My address spaces
exhibited the same behavior when manually started.

What you should do is switch to GOAL mode "V WLM,MODE=GOAL". Make sure you
have the WLM Environment variables and procedure defined in the Application
section of WILMA and the address space will start automatically when it is
first referenced by the procedure. I have noticed that the address space
stays up longer once it has been referenced, but eventually it will
gracefully shut down.

Dave Booher
Systems Programmer
Quest Software


-----Original Message-----
From: Dempsey, Michael [mailto:[login to unmask email]
Sent: Thursday, January 04, 2001 1:53 PM
To: [login to unmask email]
Subject: DSNMLM Started Task


Hey Folks...
We're new to WLM.. When we start the DSNWLM, it ends within 5 minutes
with a CC=0. Is this normal? Or should it always be up and running?

Michael Dempsey
UNC Health Care System