DB2 - L

Expand all | Collapse all

DSNTIJCV on DB2 FL100

  • 1.  DSNTIJCV on DB2 FL100

    Posted May 09, 2021 07:21 AM
    Hi All,

    Currently we are running DB2 V12 FL100  ,we are planning to run DSNTIJCV to convert all DB2 Catalog and Directories in DB2 V12 FL100.
    Can any one suggest any Implications are suggestions on this. We start our Test DB2 in access maint mode and we run DSNTIJCV.

    Chandra


    ------------------------------
    Chandra SekharRunkuWIPRO
    ------------------------------


  • 2.  RE: DSNTIJCV on DB2 FL100

    Posted May 11, 2021 04:40 AM
    Hello Chandra,

    If you can run in MAINT mode you are in a good starting position. However, if you are data sharing and the other members are active but not in MAINT mode then there is the possibility of contention on the catalog and directory. Therefore running DSNTIJCV requires careful planning to run at the quietest possible time. You could consider splitting DSNTIJCV into separate jobs, but again you need to take care when doing this to ensure that all the job steps that belong together are in the same job and that the jobs are run in the correct order.

    Kind regards,

    Gareth Copplestone-Jones

    ------------------------------
    Gareth Copplestone-Jones
    Triton Consulting
    ------------------------------



  • 3.  RE: DSNTIJCV on DB2 FL100

    Posted May 11, 2021 01:49 PM
    Thank you Gareth for your response

    Chandra